APH techniek

All data are considered to be unbinding reference values. We accept no liability for data selection that is not confirmed in writing. Pressure data refer, if not otherwise indicated, to liquids of Group II at +20°C. 8 Vacuum accessories Suitable: These vacuum filters are used particularly in vacuum generators (pumps and blowers) with design-dependent sensitivity. Materials: Housing: Steel sheet painted black, filter insert: Special paper in a double housing made from steel sheet (may be blown out in event of dried dirt) Pore width: 5 - -7 µm - An extremely high separation efficiency is realised due to the large surface of the filter paper! Suction performance Type Thread (m³/h) H Ø D F 38 VU G 3 / 8 “ 10 88 72 F 12 VU G 1 / 2 “ 20 93 96 F 34 VU G 3 / 4 “ 50 93 96 F 10 VU G 1“ 70 96 120 F 114 VU G 1 1 / 4 “ 150 160 162 F 112 VU G 1 1 / 2 “ 200 197 160 F 20 VU G 2“ 300 258 185 F 30 VU G 3” 680 270 185 F 38 VU E F 12 VU E F 34 VU E F 10 VU E F 114 VU E F 112 VU E F 20 VU E F 30 VU E Vacuum filters Suction performance 10 to 680 m³/h H D The optimum protection of your va- cuum generator from soiling! TIP G L D CH Type G L D CH PN Open. pressure (approx.) RUCK 38 VU G 3 / 8 “ 55.0 34.5 SW 23 25 bar 0.02 bar RUCK 12 VU G 1 / 2 “ 58.5 34.5 SW 27 25 bar 0.02 bar RUCK 34 VU G 3 / 4 “ 65.0 41.5 SW 33 25 bar 0.02 bar RUCK 10 VU G 1“ 74.5 48.0 SW 40 25 bar 0.02 bar RUCK 114 VU G 1 1 / 4 “ 83.0 60.5 SW 50 18 bar 0.02 bar RUCK 112 VU G 1 1 / 2 “ 93.0 71.0 SW 55 18 bar 0.02 bar RUCK 20 VU G 2“ 101.0 87.0 SW 70 18 bar 0.02 bar RUCK 212 VU G 2 1 / 2 “ 122.0 120.0 SW 87 12 bar 0.02 bar RUCK 30 VU G 3“ 141.5 140.0 SW 101 12 bar 0.01 bar RUCK 40 VU G 4“ 158.5 172.5 SW 128 12 bar 0.01 bar Check valves for vacuums up to 25 bar Materials: Housing: Brass, spring: Stainless steel, seal: NBR Temperature range: -20°C to max. +100°C Operating range: Water (no steam), neutral, gaseous and non-aggressive, liquid media, mineral oils, compressed air, low vacuum For vacuum L These valves are generally delivered with coils and plugs! 69 132 168 Vacuum filters Multifix model series 2 Input pressure: -0.965 to 0 bar Condensate draining: None Pore width in the filter: 3 µm ATEX: Operating material without its own potential source of ignition in accordance with Directive 2014/34/EU Optional: Version with protective cage -S , version with metal bowl and inspection tube -M F W 2 KP 2 V 38/100 Type Thread FVK 33 G 1 / 2 “ type FVU 6 Vacuum filters for pipe installations Type Hose Ø With push-in fittings FIQS 4 4 (external) FIQS 6 6 (external) FIQS 8 8 (external) FIQS 10 10 (external) One-way filters without clips FVU 6 6 (internal) Suitable: This filter is inserted directly in the hose behind the consumer. Materials: Housing: Plastic, filter element: Paper Temperature range: -10°C to max. +80°C Pore width: 10 µm Supply volume: The filter is delivered fully along with the fixing clamp. type FIQS FIQS FILTER 1 FIQSK 1 FIQS FILTER 1 FIQSK 1 FIQS FILTER 2 FIQSK 2 FIQS FILTER 2 FIQSK 2 --- --- Vacuum regulators with external leakage 4 - 70 m³/h Suitable: With a preset vacuum level this valve breathes the atmospheric air and prevents the vacuum level from excee- ding beyond the desired vacuum value. It is used to adjust a vacuum system with the same operating vacuum. The set- ting is done using a fine thread of the valve and the mechanical opening due to the spring load. Suction performance Thread (m³/h) L SW R 18 VU B G 1 / 8 “ -1 to -0.33 bar 4 45 12 R 12 VU B G 1 / 2 “ -1 to -0.33 bar 20 57 24 R 34 VU B G 3 / 4 “ -1 to -0.33 bar 40 60 30 R 10 VU B G 1“ -1 to -0.33 bar 70 65 35 The vacuum can also be controlled when there is a permanent leakage in the vacuum system. This can be achieved by one of our needle valves (see page 294). Type replace. filter Pressure regulator range Type brass nickel-plated Type fixing clamps Mounting brackets Type filter elements Coupling kit Replace. filter APH Techniek BV - Wateringen - T +31 (0)174 219 200 - sales@aphtechniek.nl - www.aphtechniek.nl 509